Touch-n-Flow System is a 3-piece set including the popular Touch-n-Flow applicator, applicator squeeze bottle and Plast-i-Weld liquid solvent cement. Use of the squeeze bottle makes a convenient way to fill and empty the Touch-N Flow applicator.
Applicator Squeeze Bottle and Liquid Solvent Cement.
TOUCH N FLOW SYSTEM
“Touch-N-Flow” is a lightweight, easy-to-handle applicator for liquid solvent cements. Save your brushes for painting; with “Touch-N-Flow” you can…
Join Seams with a Single Continuous Application - No Stops to Refill a Brush
Apply a Micro-Droplet with Pin-Point Accuracy
Reach Into Tight Corners without Runs or Smears
“Touch-N-Flow” holds plastic solvent cements ready for immediate use. Bottle remains closed and off the work-bench… eliminating evaporation and accidental spillage.
In case the Touch-N-Flow gets plugged up, here’s a way to get it started again.
Fill the bottle no more than 1/2 to 3/4 full. Take the metal tube off the bottle and insert the Touch-N-Flow in through the cap of the bottle, keeping the tip of the needle approximately 1/8" off the bottom. Let it stand and soak for approximately 5 minutes. When the glass part of the Touch-N-Flow begins to fill by itself, you know the tip is clean. If it does not start by itself, you may squeeze the plastic bottle slightly to get it started.
That’s all there is to it!
If you would like to empty the Touch-N-Flow, you may insert the needle into the large stainless steel tube and it will empty itself.
Another way is… leave the Touch-N-Flow on your workbench after you have finished working. It will evaporate and leave the Touch-N-Flow ready for next time.