UMS16 Photo Etch BFR-TRI BENDER (Bend / Fold / Roll)

BFR Tri Bender

This one tool allows you to accomplish three separate tasks with photo-etched material or wire.
They are BEND, FOLD, and ROLL (BFR).
The top plate has several surfaces useful for bending photo-etched pieces.
Just loosen the screw and plate, slip your material under the appropriate shape, and bend.
Additionally, you can also bend wire by using the slots on the edge of the base plate.
Slip the wire in and bend it over the required length.
Finally, flip the tool over and you will find several round groves with corresponding rollers.
These are perfect for forming curved pieces. You can use this handy tool on any of your modeling projects.

Made from aluminum, this tool is approximately 2.5 inches by 3.0 inches on the sides and 1.25 inches high.
Each of the four rollers are approximately 2.25 inches long.